Body - Door Seal Flange Corroded
SI M 41 02 06
Body
January 2007
Technical Service
This Service Information bulletin supersedes S.I. M41 02 06 dated January 2007.
[NEW] designates changes to this revision
SUBJECT
Corrosion on Door Seal Flange
MODEL
R50, R52, R53 (Cooper, Cooper Convertible, Cooper S)
SITUATION
The customer may complain that they have noticed areas of corrosion under the door seal, on the horizontal door flange.
CAUSE
Water seeping under the door seal and collecting in this area may lead to corrosion in certain heat and humidity conditions.
CORRECTION
On a customer complaint basis, the recommended paint and body repair should be performed.
PROCEDURE
1. Verify the customers complaint by removing the lower part of the door seal (1) and inspecting the horizontal portion of the flange for
corrosion.
2. [NEW] Take clear digital photos of all affected areas. These photos must be retained for warranty and records purposes.
[NEW]NOTE:
The date stamp feature of the camera should be turned ON, so this date appears on the photo.
3. Heavy corrosion will require sanding and painting.
The following paint and body repair should be performed to the horizontal surface of the affected flange [s] only.
a. Prepare the surface by cleaning with a solvent based cleaner.
b. Paper the area surrounding the work area.
c. Use an 80 grit Roloc Bristle Disk on the affected area.
2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 263
d. Sand the affected area with P180 grit paper followed by P220 and then P320 grit paper.
e. Blow and tack off the area to be sprayed.
f. Use etch primer or epoxy primer followed by primer surfacer after allowing the correct flash time.
g. Lamp (IRT) the area for 5 10 minutes at 80锟斤拷 C.
h. Sand and feather the edge primer surfacer with wet P800 grit sand paper
i. Blow and tack off the affected area.
j. Apply BMW specified base coat.
k. Apply BMW specified clear coat.
l. Allow a flash time of 5 10 minutes
m. Lamp (IRT) the affected area for 25 30 minutes at 60锟斤拷 C.
n. Re-install the door seal
WARRANTY INFORMATION
Covered under the terms of the MINI Rust Perforation Limited Warranty.
Defect Code 41 35 00 75 00
[NEW] NOTES:
^ The aforementioned paint and body repair may be claimed under the same defect code and charged to Sublet Code: 3.
^ When performing the above noted paint and body repair under this bulletin only, market team approval is not required.
^ A hard copy of the requested photos must be attached to the affected vehicle's repair order and retained with the vehicle's file.
^ Failure to retain the requested photos could result in a delayed or refused warranty claim payment.
