^ At the online DVD order site, by clicking on the FAQs link (see ORDERING A DVD). ***Acura ZDX V6-3.7L Technical Service Bulletin # 11-029 Date:
110930
Body - Front Inner Fender Warped/Not Flush With Fender
11-029
September 30, 2011
Applies To:
2010-11 ZDX - ALL
Front Inner Fender Is Warped, Does Not Fit Flush Against the Fender
SYMPTOM
57
The front inner fender is warped, creating a gap at the rear of the front wheelwell.
PROBABLE CAUSE
The inner fender warped in high temperatures.
CORRECTIVE ACTION
Replace both front inner fenders, and install fender stiffeners using new screws.
PARTS INFORMATION
Left Inner Fender:
P/N 74151-SZN-A00
Left Fender Stiffener:
P/N 741 52-SZN-A00
Right Inner Fender:
P/N 74101-SZN-A00
Right Fender Stiffener:
P/N 741 02-SZN-A00
Screw, 5x20 (12 required):
P/N 90103-TA0-000
TOOL INFORMATION
Push Pin/Grab Rail Cap Pliers:
T/N 07AAC-001A100
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number: 8131J8
Flat Rate Time: 0.6 hour
Failed Part: 74151-SZN-A00
Defect Code: 00401
Symptom Code: 00101
Skill Level: Repair Technician
58
REPAIR PROCEDURE
NOTE:
^ Put gloves on to protect your hands.
^ Take care not to scratch the body.
1. Raise and support the vehicle.
2. Remove the wheel nuts and the front wheels.
3. Remove both front inner fenders:
^ Remove the nine screws.
^ From under the front bumper, remove the bolt and detach the two clips securing the bumper and the inner fender.
^ Using the push pin pliers, remove the 11 remaining clips securing the inner fender to the body.
NOTE:
Discard the six screws and use the new ones with a smaller head.
4. Install the new inner fender and stiffener:
59
^ If any clips are damaged or stress-whitened, replace them with new ones.
^ Push the clips into place securely. Torque the bolt to 7.4 N.m (5.5 lb.ft)
