Computers/Controls - 'Retrofit' Update Programming
2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 252
SI B 01 09 06
Warranty
February 2007
Technical Service
This Service Information bulletin supersedes S.I. B01 09 06 dated November 2006.
Changes to this revision are identified by a black bar.
[NEW] designates changes to this revision
SUBJECT
Defect Code for Programming Prior to Accessory Retrofit
MODEL
All
GENERAL INFORMATION
Software update programming is sometimes required as part of an electronic accessory installation. When connecting to Progman to perform
"Retrofit Coding", the Status Report will indicate if a software update is required. This software update must be performed before the "Retrofit
coding" can be carried out.
A software update to prepare the vehicle for the "Retrofit Coding" of an accessory is covered under the New Vehicle Limited Warranty and must be
claimed using defect code 72 60 93 02 00.
Any other Progman programming and recoding of the vehicle software specifically associated with the installation of the accessory should be
included in the customer pay installation charge. See Parts Information Bulletin 65 12 04.
For additional information concerning warranty claims for software update programming (Progman), refer to SI B01 03 06.
WARRANTY INFORMATION
The software update and any control module replacement required to prepare the vehicle for the "Retrofit Coding" of the accessory is covered under
the BMW New Vehicle Limited Warranty. All control modules must be identified by the Measures Plan or Status Report created by Progman.
The "Retrofit Coding" of the vehicle software specifically associated with the installation of the accessory is included in the customer pay installation
charge. See Aftersales Bulletin 65 09 06.
Software update that is performed as a result of an accessory retrofit:
Defect Code 72 60 93 02 00
Refer to the latest KSD version for appropriate labor allowances.
The warranty claim must include in the "Comments" section a clear reason for the programming work for example, "Software update for satellite
radio retrofit".
All claims must be supported by copies of the Measures Plan and Final Reports produced at each stage of the programming process. These
documents are to be printed and attached to the customers work order.
[NEW] NOTE: In cases where Progman requires the replacement of control modules, or additional programming, because certain control modules
failed to program correctly; the Labor Operation, and Labor Allowance for this additional work should be selected from KSD and all work claimed
under the original Defect Code.
