Saturday, 13 October 2018

Cooling System - SES Lamp ON/DTC P0128 Set


Cooling System - SES Lamp ON/DTC P0128 Set



Service Measure



Engine Electrical



M12 201 05



03/25/2005



Subject



DME (EMS2000 or MS5150) Fault Code P0128 - Coolant Thermostat



Model



R50 (Cooper) R52 (Cooper and Cooper S) and R53 (Cooper S) equipped with W10 and W11 engines.



Complaint



2002-2006 Mini Cooper (R50) L4-1.6L (W10) Page 94



The customer complains the Service Engine Soon Lamp is illuminated. When diagnosed the following fault is found in the DME (EMS2000 or



M55150) memory.



Fault Code P0128 - Coolant thermostat coolant temp below thermostat control temp



Cause



An air pocket in the cooling system can cause operational errors of the cooling system causing faults to store in memory. One of the following areas



can be the cause.



1. Air pockets near the engine thermostat can cause the thermostat to have a delayed opening. This will cause a slight over temperature in the



engine cooling system for short period of time signaling the DME with incorrect data via the coolant temperature sensor.



2. Air pockets near the engine coolant temperature sensor can incorrectly inform the DME of proper engine temperature during the warm up



phase.



If the DME is supplied with incorrect cooling data during the warm up phase then the calculation for the virtual radiator outlet temperature can also



be inaccurate causing the above fault to store in memory.



Measure



1. Bleed cooling system.



2. Do not replace any parts.



3. Connect vehicle to a FASTA transmitting diagnostic device and perform short test. Once the short test has concluded verify the vehicle has



been identified properly.



4. If a resolution cannot be found through bleeding of the cooling system then please submit a PuMA Case to the Drivetrain Technical Hotline